I'm getting exactly 50 degress difference between infrared thermometer and multimeter reading. 120 ohms vs 170 degrees. Truck has 180k, assuming temp sensor has never been replaced. I couldnt find any info about resistance range for temp sensor in my Haynes manual. Also, this is for the gauge sensor, not the ECU. Reply Like.
Ambient Temperature replacement on Ford Mondeo MK4. This sensor is also also outside air temperature sensor. when it mulfunction, your car will be showing te 【TOP DEAL】⚡️ Order Temperature sensor for FORD Mondeo Mk5 Hatchback (CE) 2.0 TDCi 150 hp T7CN easily at AUTODOC Fast delivery and low prices Discover now for yourself 21. Ford Model: mondeo 2.5i v6 si. Posted December 11, 2008. diconect your thermostat your heater will cool down a lot but your car wont lose any power on the motor way just keep checking your coolant and oil regulary thats the cheats way and the quickest and the cheapest. Quote.

SOURCE: where is coolant temp sensor located on 2003 gmc. heres a diagram to show you where the coolant temp sensor is located, its behind the alternator on the left side (driverside),the sensor just unplug the connector and then unscrew it and out it comes. Posted on Jun 21, 2010.

I may be wrong, but i think thats the "solar" sensor that measures the effect of the sun on the car. The ambient temp sensor is in the front of the bonnet, in front of the radiator, near the air bottle. Beat me to it Aussie!! :driver:1998 EL XR6 - Manual! :driver: K&N Panel Filter . Ford Premium Audio Pack .

Shows the testing of a NTK Exhaust Gas Temperature Sensor.More info, tips and tricks about our products:
Hi, on the mk3, the temp sensor is on the back of the fuel pump.. I assume it's the same on the MK4. So, when you replaced the fuel pump you introduced a new temp sensor. If you've still got the old one, can you swap em over?
The PCM compares the EGR temperature sensor ”A” readings with values programmed into its memory. If the voltage is too high, it will set the generic code P040D. The common causes of the P040D code include a damaged or faulty EGR temperature sensor, circuit issues, or a PCM issue.
Save. 62K views 5 years ago. This is how the temperature sensor on Ford Mondeo MK4 2.0 TDCI is replaced. Time 20 minutes. Tools: flat screw driver. Items to take off; battery cover, air Between the battery and the suspension tower you will find a round plug, This plug is used on Series 1 AU for the coolant level sensor! Ford used a loop plug to cancel this but the earth goes bad so it needs to be upgraded! Find the Yellow with Red stripe wire and make a connection to the Negative on the Battery. The location of the Ford Intake Air Temperature Sensor can vary depending on the model and year of your vehicle. In most cases, however, it is located between the air filter and the throttle body. In some Ford models, such as the F-150, the IAT sensor is integrated with the Mass Airflow (MAF) sensor. Here is an overview of the different The ambient temperature sensor was misreporting saying it was below freezing. This is a quick fix with a simple clean.
Cool thanks, the coolant sensor problem seems to be getting worse and after a 10 mile run tonight the engine light is on (P1288 stored and P1288 pending) so I'll get that ordered as well as the boost hose (Im assuming it will be the CHT sensor then and I need to remove the pulley on the cam to change it - any special puller needed for that?)
72hcL.
  • 92f4cle7c9.pages.dev/408
  • 92f4cle7c9.pages.dev/268
  • 92f4cle7c9.pages.dev/565
  • 92f4cle7c9.pages.dev/464
  • 92f4cle7c9.pages.dev/179
  • 92f4cle7c9.pages.dev/194
  • 92f4cle7c9.pages.dev/320
  • 92f4cle7c9.pages.dev/179

    • ford mondeo temperature sensor location